Fully Integrated Production From Engineering to Shipment
From the preparation of the composite compound to the quality control laboratory, we carry out every stage in our own facility, in a controlled manner and in compliance with standards.
Controlled Process, Consistent Quality
Composite product quality depends as much on the discipline of the production process as on the quality of the raw material used. Kent Teknik Kimya carries out almost the entire production chain in-house: engineering design, pattern shop, mould production, composite compound preparation, pressing and quality control processes are all gathered under a single discipline.
Thanks to this integrated structure, we can carry out high-volume mass production of standard products while also offering flexible solutions in project-specific sizes and specifications. The controls applied at every stage ensure that our products safely meet the load classes required by the TS EN 124-5 standard.
Mass Production Capacity
High-volume, consistent production across a wide product range with our hydraulic press lines.
Project-Based Custom Production
Project-specific mould and production solutions in non-standard sizes and specifications.
Our Own Mould Shop
Having the pattern shop and mould production in-house means speed, flexibility and quality control.
Accredited Testing Approach
Standard assurance in every batch with load class (A15–D400), dimensional and surface checks.
From Raw Material to Finished Product
The production journey of our composite infrastructure products consists of seven basic stages.
Engineering & Design
Product geometry, load class and mould design are prepared with computer-aided engineering (CAD/CAE); strength calculations are made.
Pattern Shop
Precise patterns and moulds are produced for the approved design. The pattern shop is the foundation of quality and dimensional consistency.
Composite Compound Preparation
Glass fibre, polyester resin, filler and additives are turned into SMC/BMC compound according to the specified recipe.
Moulding (Pressing)
The ready compound is moulded in hydraulic presses under high pressure and temperature. At this stage the product reaches its final strength.
Deburring & Assembly
The burrs of the pressed products are cleaned; accessories such as gaskets, locks and hinges are fitted.
Quality Control & Laboratory
Every batch undergoes dimensional, surface and load tests. TS EN 124-5 load class tests are applied in our laboratory.
Packaging & Shipment
Approved products are packaged safely, labelled and shipped to the planned address on time.
Every Batch Is Tested, Every Product Is Certified
The controls and laboratory tests we apply at every stage of production ensure that our products meet the performance they promise in the field. Our ISO 9001 quality management system makes this discipline permanent.
